各位大侠:小弟遇到问题，虚心请教！ 单位一台H3C S2126交换机 配置如下：
<sqbgl-s2126>dis cu
---- More ----
#
sysname sqbgl-s2126
The monitor port has not been configured!
#
vlan 1
#
interface vlan-interface1
ip address 192.168.3.230 255.255.255.0
ip gateway 192.168.3.10
#
interface Ethernet0/1
#
interface Ethernet0/2
#
interface Ethernet0/3
#
interface Ethernet0/4
#
interface Ethernet0/5
#
interface Ethernet0/6
#
interface Ethernet0/7
---- More ----
#
interface Ethernet0/8
#
interface Ethernet0/9
#
interface Ethernet0/10
#
interface Ethernet0/11
#
interface Ethernet0/12
#
interface Ethernet0/13
#
interface Ethernet0/14
#
interface Ethernet0/15
#
interface Ethernet0/16
#
interface Ethernet0/17
#
interface Ethernet0/18
#
interface Ethernet0/19
#
interface Ethernet0/20
#
interface Ethernet0/21
#
interface Ethernet0/22
#
interface Ethernet0/23
#
interface Ethernet0/24
#
interface Ethernet0/25
#
interface Ethernet0/26
duplex full
speed 100
#
user-interface aux 0
user-interface vty 0
#
<sqbgl-s2126>
请问配置有没有问题？
我想配置TELNET
但是无法建立并配置本地用户
[sqbgl-s2126]local-user admin
^
% Unrecognized command found at '^' position.
[sqbgl-s2126]loc "按TAB"
[sqbgl-s2126]localuser
[sqbgl-s2126]localuser admin admin 1
Error: the same level user has already existed!
在线等啦 不胜感谢
只能使用密码验证登录
如下配置：
user-interface vty 0
set authentication password 密码
参考资料：H3C金牌代理商工程师-为你解决！！
password cipher 密码
authorization-attribute level 3
service-type telnet terminal
user privilege level 3
set authentication password simple 11111本回答被网友采纳
H3C s2126交换机 划分两个vlan通过同一端口上外网,怎么配置?
S3100(用e0\/1口接S2126 e0\/1)interfce e0\/0\/1 port link-type trunk port trunk permit vlan 2 3 4 E1\/0\/1和路由器接口都应该配个地址 S2126配置如1楼，每个VLAN加一个地址
