有些坐标给的不全，我这也没机床测试，仅供参考希望能给你有所帮助！
G95M3S1000
G0X52
Z3
T1D1
CYCLE95( "TT:TT_E", 0.80000, , ,0.20000, 0.30000, 0.30000, 0.10000, 9, , ,)
CYCLE94( 20.00000, -20.00000, "E", 0)
T2D1
CYCLE93( 30.00000, -31.00000, 7.00000, 5.00000, 0.00000, 0.00000, 0.00000, 1.00000, 1.00000, , ,0.20000, 0.20000, 0.50000, 1.00000, 1, )
G00X50
Z0
CYCLE99( 0.00000, 20.00000, -18.00000, 20.00000, 2.00000, ,2.50000, 0.20000, 0.00000, 0.00000, 3, 1, 2.50000, 300101, 1, ,0, 0, 0, 0, 0, 0, 0, 1, , , ,0)
G17
T3D1
CYCLE82( 15.00000, 0.00000, 5.00000, -20.00000, 0.00000, 1.00000)
G18
T1D1
CYCLE99( 0.00000, 6.00000, -18.00000, 6.00000, 2.00000, , 1.20000, 0.20000, 0.00000, 0.00000, 1, 1, 1.00000, 300102, 1, 3.00000, 0, 0, 0, 0, 0, 0, 0, 1, , , ,0)
M30
;*************CONTOUR************
TT:
;#7__DlgK contour definition begin - Don't change!;*GP*;*RO*;*HD*
G18 G90 DIAMON;*GP*
G0 Z0 X16 ;*GP*
G1 X20 CHR=2 ;*GP*
Z-20 ;*GP*
X30 CHR=1 ;*GP*
Z-35 ;*GP*
X40 CHR=1 ;*GP*
Z-50 ;*GP*
X50 ;*GP*
;CON,V64,2,0.0000,0,0,MST:1,2,AX:Z,X,K,I;*GP*;*RO*;*HD*
;S,EX:0,EY:20,ASE:90;*GP*;*RO*;*HD*
;F,LFASE:2;*GP*;*RO*;*HD*
;LL,EX:-20;*GP*;*RO*;*HD*
;LU,EY:30;*GP*;*RO*;*HD*
;F,LFASE:1;*GP*;*RO*;*HD*
;LL,EX:-35;*GP*;*RO*;*HD*
;LU,EY:40;*GP*;*RO*;*HD*
;F,LFASE:1;*GP*;*RO*;*HD*
;LL,EX:-50;*GP*;*RO*;*HD*
;LU,EY:50;*GP*;*RO*;*HD*
;#End contour definition end - Don't change!;*GP*;*RO*;*HD*
TT_E:;************* CONTOUR ENDS ************
